Zero-Emission Thermal Power Generation

Carbon Solution Strategy of IHI Corporation

Exhibitor: IHI CORORATION
a) De-carbonization of electric power sector by fuel ammonia - Demonstration of ammonia co-firing in a coal-fired power plant - Novel supply chain of fuel ammonia b) Utilization of nuclear power & new generation reactor c) Local use of local renewable energy - Power to X(heat, gas, fuel, etc.) technology d) Carbon capture and its recycle - De-carbonized fuel by methanation - De-carbonized feedstock by CO2 olefin synthesis e) Negative carbon emission by CCS and BECCS

TR-COM (Rotating Machine Monitoring)

Exhibitor: TORISHIMA PUMP MFG. CO., LTD.

Water electrolysis hydrogen production equipment

Exhibitor: MIKUNI KIKAI KOGYO CO., LTD.
Pure 99.999% hydrogen can be generated by AEM water electrolysers which have both advantages of popular alkaline electolysers and PEM electrolysers AEM electrolyser can run stably under the highly fluctuated power load created by solar panel and / or wind power. It is also economical without noble metals like platinum required for PEM electrolysers. The bigger system consists of several segments with small “AEM stacks” which allow segmental operation even if any stack fails.

GX (Greenhouse Gas Reduction Equipment, Green Transformation)

Exhibitor: JAPAN INSTITUTE OF FUTURE SCIENCE INC.

High Performance Oil Purifier/Hydraulic Oil Purifier PEC

Exhibitor: TRIBO SYSTEM CO., LTD.
 

Magnetic Drive Pump for Liquefied Ammonia ML-N Model, MML-N Model

Exhibitor: SANWA HYDROTECH CO.
 

Portable Scope for Coal Boilers

Exhibitor: KANDEN PLANT CO.

MAGNETIC INDUCTION HEATING MACHINE - Helios35+

Exhibitor: NUOVA SIMAT SRL
Ideal for BOLTING operations on turbine/compressor/valve casings and SHRINK FITTING (retaining ring removal, impeller assembly etc.). With this system you can save up to 80% of time with respect to traditional methods (such as electrical heaters, open flames etc.) operating in total safety! It is an all-in-one system which does not need any external chiller or water source. It can be used on bolt holes from 9 up to more than 34mm and can be equipped with customized inductors!

Ion Exchange Resins

Exhibitor: MUROMACHI CHEMICALS INC.

Plate Heat Exchanger

Exhibitor: HISAKA WORKS, LTD.

Gamma density meter PM-1000A

Exhibitor: NANOGRAY INC.
Gamma density meter PM-1000A is suitable for measuring slurry density, such like gypsum slurry produced by desulfurization equipment. It can be used without any license or controlled area in Japan, because this gauge is certificated by Nuclear Regulation Authority Japan.

Automatic Equipment Diagnosis System Using Multimodal Deep Learning

Exhibitor: TOYO CORP.